Allied Vision Technologies Pike Manuál s instrukcemi stáhnout pdf (Strana 197)

Controlling image capture

PIKE Technical Manual V4.0.0

197

Changing the parameters within a sequence

To change the parameter set for one image, it is not necessary to modify the

settings for the entire sequence. The image can simply be selected via the

ImageNo field and it is then possible to change the corresponding IIDC

V1.31 registers.

Points to pay attention to when changing the

parameters

Note

•If the ApplyParameters flag is used when setting the

parameters, all not-configured values are set to default

values. As changing a sequence normally affects only

the value of a specific register, and all other registers

should not be changed, the ApplyParameters flag may

not be used here.

• The values stored for individual images can no longer

be read.

• If the camera is switched into sequence mode, the

changes to the IIDC V1.31 registers for the image spec-

ified in ImageNo take immediate effect.

• Sequence mode requires firmware 3.x and special care if

changing image size and frame rate related parameters.

This is because these changes not only affect settings

in the camera but also require corresponding settings in

the receiving software in the PC (e.g. FirePackage).

Caution

Incorrect handling may lead to image corruption or loss of

subsequent images.

Please ask for detailed support when you want to use this

feature.

1 2 ... 192 193 194 195 196 197 198 199 200 201 202 ... 331 332

Žádné komentáře

Allied Vision Technologies Pike Manuál s instrukcemi Strana 197